Allstar Products Group 6500-P Installation Manual

1 P/N 108734, REV B READ THIS MANUAL CAREFULLY BEFORE BEGINNING INSTALLATION INSTALLER: Leave this manual with your customer upon completion of the i

2 P/N 108734, REV B •THE 108733 MCB IS INTENDED FOR REPLACEMENT OF EXISTING MCB’S IN ABOVE LISTED MODELS ONLY. DO NOT USE FOR ANY OTHER PURPOSE. D

3 P/N 108734, REV B 106322 Figure 1: Schematic for 2000/2500 (pre Nov. 1992) and IIA Operators NOTE: THIS SECTION APPLIES TO IIA MODELS AND 2000/250

4 P/N 108734, REV B NOTE: On 310/510 Models, the radio receiver was built onto the motor control board. It will be necessary to install a 9921 recei

5 P/N 108734, REV B NOTE: On SPRINT & 200/250 OPERATORS, the radio receiver was built onto the motor control board. It will be necessary to inst

6 P/N 108734, REV B NOTE: THIS SECTION APPLIES ONLY TO 2000 AND 2500 MODELS BUILT IN NOVEMBER AND DECEMBER, 1992, see Section A for units built befor

7 P/N 108734, REV B NOTE: THIS SECTION APPLIES TO THE FOLLOWING MODEL OPERATORS: 3000, 3500, 3500-P (PDQ), J3000, J3500, 6000, 6500, 6500-P (PDQ) AN

8 P/N 108734, REV B NOTE: If original MCB “MC1” is installed, it will be necessary to do some rewiring when installing the 108733 MCB in Model 325B (